China Stainless Steel Lashing Wire manufacturers
Stainless Steel Lashing Wire is used in a lashing machine to lash a single aerial cable or a combination of cables to a supporting messenger strand.
A specially controlled annealing process yields a uniform, fine grain structure throughout wire length and cross section for best results
The lashing wire is packaged as 6 coils per carton for your ordering convenience
Is available in a 200,300,400 series stainless steel alloy
Type 430 Stainless
Low carbon, 17% chromium wire
Suitable for general use and in ordinary atmospheric exposure
Will acquire only a dark surface stain
Specifically not recommended for use within 25 miles of salt water or industrial operations which emit pollutants
Type 302 Stainless
18% chromium, 8% nickel analysis
This wire has excellent resistance to corrosion from industrial atmospheres
Its higher tensile strength and breaking load are an added benefit
A .038 in. diameter Type 302 wire provides strength equal to a .045 in. type 430 wire with better ductility (easier bending and unwinding) and better elongation (less chance of wire breakage from stress)
Type 316 Stainless
Modified 18-10 analysis containing approximately 2.5% molybdenum
More resistant to the corrosive action of most chemicals, including chlorides and sulfides, than any other wire
Particularly resistant to pitting and pin hole corrosion of the kind commonly caused by salt spray
Its use provides the best insurance against failure under the most severe atmospheric conditions
All lashing wire is wound in a straight hub configuration to fit all the standard GMP lashes
Buying tip:?When estimating the length of lashing wire required for a cable run, add the following amounts to the length of the run for single lashing.
For wire types other than shown above consult the factory.
Factory name:Jiangsu Jaway Stainless Steel Products Co.,Ltd
Contact person:Ms.Joly Tang
Phone/Wechat:0086 13816748645
Skype:jawaysteel808
Website:www.jawaysteel.com
Related Products
